SDI AXLE 2.0 (Front Only)

SPECIAL BUILD STEPS REQUIRED
- Cutting Plastic Tubes To Your Desired Width.
- Cutting The Front CVD To The Necessary Length.
- Cut the Steering Rod To Match Your Axle Width.

1.- CHOOSE YOUR CUSTOM WIDTH 


AxleSketcher    Use this intuitive axle sketcher system, just drag the parts to see the inner tubes length you need for your axle.


You can also use one of the links bellow to choose your inner tubes length and to know all other necessary dimensions you will need.
Note other users might be using the same sheet at the same time, if so get back here and click on other link.

AxleCalc1    AxleCalc2

 2.- CLICK ON PRODUCT CUSTOMIZATION TAB  to enter the values.

 3.- STEP BY STEP BUILD UP MANUAL  HERE IN OUR FACEBOOK PAGE :-) 

PART LIST:
- METAL PARTS
2 x InnerTubes (Custom Cut as per customer specification)
2 x Front CVD Shaft
2 x Front CVD Cylinder
2 x Front CVD Cup
2 x Front CVD Pin
1 x Pinion
1 x Spur Gear (Spool)
1 x Steering Rod
1 x Pinion Spacer

- PLASTIC PARTS
1 x Diff Box
1 x Diff Box Cover/Output
2 x Axle Tube (Mixed Front/Rear)
2 x Front Axle End Half C
2 x Knuckle
2 x Steering Rod End
1/0 x Steering Extension Kit (3D print + long grub Screw) (only needed for wider axles)
1 x 4.7mm ball Rod End (For Steering Rod link)

-SCREWS
1 x M2 SDI Ball Screw (For Steering Rod Link)
6 x M1.6x12mm Allen Head (fasten Diff Box Cover)
2 x M1.6x5mm Allen Head (fasten Diff Box Cover only on the meridian of the part)
8 x M3x4mm set screw dog point (lock plastic axle housing with inner tune)
4 x M2x14mm Allen Head (fasten front axle half C)
2 x M2x10mm Allen Head (joints Knuckles with Steering Rod Ends)

- BEARINGS & SHIMS
2 x 10x6mm (Bevel Spur Gear / Spool)
2 x 15x10mm (CVD Cup)
2 x 8x4mm (Pinion)
2 x 9x5mm (CVD Cup and Rear Shaft))
4 x 6x3mm (Knuckle King PIn)

YOU NEED TO MAKE YOUR OWN UPPER LINK.
Here you have four options in order of difficulty (link the images to see measures)